The 2005 Ford Expedition has a fuel pump driver module located in the rear cargo area. The module is located behind the left rear seat and is readily accessible once the seat is folded down. Two screws secure the module to the floor, and these must be removed before you can access the module. Once the screws are removed, the module can be pulled out and replaced with a new one. The entire process should take no more than 30 minutes to complete.
Contents
Where Is The Fuel Pump Driver Module Located?
The fuel pump driver module is located in the engine compartment, on the side of the car, near the firewall. It is a small, rectangular box with two wires coming out. The module is responsible for sending a signal to the fuel pump to turn on and off. When the car is turned on, the module sends a signal to the fuel pump to turn on. The pump then pressurizes the fuel line and sends gasoline to the engine. When the car is turned off, the module sends a signal to the fuel pump to turn off. This prevents gasoline from leaking out of the engine and onto the ground. The module is usually located near the fuse box to be easily accessed for repairs or replacement.
Does A 2004 Expedition Have A Fuel Pump Driver Module?
The 2004 Ford Expedition has a fuel pump driver module (FPDM) located on the frame near the fuel tank. The FPDM monitors the fuel pressure and controls the voltage to the fuel pump. It also contains a relay that supplies power to the fuel pump. If the fuel pump does not receive power, it will not be able to pump fuel to the engine, and the vehicle will not run. The FPDM is an important part of the fuel system and is necessary for the vehicle to run properly.
Where Is The Fuel Pump Driver Module Located On A 2004 Ford Expedition?
The fuel pump driver module is located on the frame rail near the vehicle’s rear. It is mounted to the frame with two bolts.
This fuel pump relay is located in the power distribution box. The power distribution box is located under the hood on the vehicle’s driver’s side. The relays are numbered and can be found in numerical order from left to right. The fuel pump relay is number thirty-seven. There is a diagram on the lid of the power distribution box that shows the location of all of the relays. The fuel pump driver module has four wires going to it. Two of the wires are for the fuel pump, and two are for the fuel level sender. The wire colors are black and pink, black and white, red and black, and red and white. These wires can be found in connector C412 on the main wiring harness behind the instrument panel cluster.
Does A 2007 Ford Expedition Have A Fuel Pump Driver Module?
The 2007 Ford Expedition does not have a fuel pump driver module. It does, however, have a fuel pump relay. The relay is located in the central junction box, which is under the hood on the vehicle’s driver’s side. The relay controls the power to the fuel pump. If the relay fails, the fuel pump will not receive power, and the engine will not start. This can be a frustrating problem for drivers, as it can be difficult to diagnose the cause of the problem. However, a trained mechanic should be able to identify the problem and replace the relay if necessary quickly. In most cases, replacing the relay is a relatively simple and inexpensive repair.
Final Verdict
The fuel pump driver module is located in the vehicle’s rear, near the fuel tank. It is responsible for supplying power to the fuel pump, and it is located between the fuel pump and the engine. The module is typically mounted on the vehicle’s frame, and it is connected to the fuel pump by a series of wires. The module may also be located in the engine compartment in some cases.
The fuel pump driver module is an important component of the vehicle’s fuel system, typically controlled by the engine computer. A separate controller, in some cases, may also control the module. If the module fails, it can cause the engine to stall or fail to start. It can also cause the vehicle to run rough or misfire in some cases.